Configuring Quest II EMV and Secure MSR

From Rts
Jump to: navigation, search

This section only applies if the Quest tablet being configured has An EMV Read and Secure MSR.


The device will need two drivers installed.
1) Microsoft POS for .Net v1.14
2) Quest II MSR OPOS Driver


Once Installed: Make the following adjustment under Setup -> Local computer -> Card Reader.


QuestII 1.PNG

Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.


NOTE: These steps also apply to the Quest III tablet.