Difference between revisions of "Configuring Quest II EMV and Secure MSR"

From Rts
Jump to: navigation, search
Line 12: Line 12:
  
 
Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then '''Save'''.
 
Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then '''Save'''.
 
  
 
'''NOTE''': These steps also apply to the Quest III tablet.
 
'''NOTE''': These steps also apply to the Quest III tablet.

Revision as of 15:59, 12 March 2019

This section only applies if the Quest tablet being configured has An EMV Read and Secure MSR.


The device will need two drivers installed.

Once Installed: Make the following adjustment under Setup -> Local computer -> Card Reader.

QuestII 1.PNG

Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.

NOTE: These steps also apply to the Quest III tablet.