Difference between revisions of "Configuring Quest II EMV and Secure MSR"

From Rts
Jump to: navigation, search
Line 12: Line 12:
  
 
Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.
 
Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.
 +
 +
 +
NOTE: These steps also apply to the Quest III tablet.

Revision as of 17:41, 25 July 2018

This section only applies if the Quest tablet being configured has An EMV Read and Secure MSR.


The device will need two drivers installed.
1. Microsoft POS for .Net v1.14
2. Quest II MSR OPOS Driver

Once Installed: Make the following adjustment under setup - local computer - Card Reader.

QuestII 1.PNG

Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.


NOTE: These steps also apply to the Quest III tablet.