Configuring Quest II EMV and Secure MSR

From Rts
Revision as of 20:38, 16 January 2019 by Rd (talk | contribs)
Jump to: navigation, search

This section only applies if the Quest tablet being configured has An EMV Read and Secure MSR.

The device will need two drivers installed.
1) Microsoft POS for .Net v1.14
2) Quest II MSR OPOS Driver

Once Installed: Make the following adjustment under Setup -> Local computer -> Card Reader.

QuestII 1.PNG

Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.

NOTE: These steps also apply to the Quest III tablet.