Configuring Quest II EMV and Secure MSR

From Rts
Revision as of 15:58, 12 March 2019 by JenG (talk | contribs)
Jump to: navigation, search

This section only applies if the Quest tablet being configured has An EMV Read and Secure MSR.


The device will need two drivers installed.

Once Installed: Make the following adjustment under Setup -> Local computer -> Card Reader.

QuestII 1.PNG

Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.


NOTE: These steps also apply to the Quest III tablet.