Configuring Quest II EMV and Secure MSR

From Rts
Revision as of 15:17, 22 May 2019 by Jonl (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This section only applies if the Quest tablet being configured has An EMV Read and Secure MSR.


The device will need two drivers installed.

Once Installed: Make the following adjustment under Setup -> Local computer -> Card Reader.

QuestII 1.PNG

Change the card reader type configured to 'OposNet:IDTECH_SECUREMAG_USBHID' then Save.

NOTE: These steps also apply to the Quest III tablet.